The Nelore ZN3® Morlan Barbed Wire arrived to complete the Nelore® line that is already recognized in the market for its quality, resistance and practicality in the installation.
It is made from heavy zinc layer for high protection against corrosion, suitable for regions that require greater protection against corrosion, such as coastal, swampy areas or with the presence of acid rain etc. For those who have properties outside these areas and / or do not need a product with a heavy zinc layer, Morlan has Nelore® Morlan and Cercaço® Morlan barbed wires, both with alternating twist and light zinc layer.
Its extremely sharp barbs are firmly positioned at a distance of 5” (125 mm) from each other (and do not move).
It is indicated for fencing large animals such as cattle and rural fences in general, especially in areas of rugged terrain and mountainous regions, as it allows the construction of fences with curves and unevenness, without compromising the stretching of the fence.
The Nelore ZN3® Morlan Barbed Wire is produced using an alternating twist technique, through which we produce a barbed wire of the highest quality and resistance, and its minimum resistance is 250 kgf. It is manufactured in accordance with the strict standards of the Brazilian Association of Technical Standards ABNT NBR 6317.
In addition, for greater protection during handling, Nelore ZN3® Morlan Barbed Wire is sold in 500 meter rolls, wrapped in special wrappers, with anatomical handles that in addition to facilitating handling, allows stacking at the point of sale.
Important: when using Nelore ZN3® Morlan barbed wire, also remember to use Nelore Morlan Fence Spacers and clamps - quality items that represent economy, resistance, practicality and agility for building the fence.
Keep out of reach of children.
Be careful when handling barbed wire.
The installation of Nelore ZN3® Morlan barbed wire must be done by qualified professionals, always with the use of suitable protective equipment. In case of questions about the installation, use the online manual.
More information about alternating twist Morlan barbed wires
Morlan was a pioneer in Brazil using this technique to manufacture barbed wires.
In this technique, we use high quality raw material that receives differentiated processing throughout the manufacturing process, resulting in a very high quality and resistant barbed wire with high advantageous cost-benefit ratio for the final consumer.
The alternating twisted barbed wire is made from rope composed of 02 wires - smaller in diameter and, therefore, lighter than those used in the continuous twisting technique - twisted clockwise and counterclockwise successively.
Its extremely sharp barbs are firmly fixed at a distance of 125 mm from each other, at the points where changes in the direction of twisting occurs, externally, wrapping the barbed rope, so that when the barbed wire is installed and stretched, the barbs work in order to hold the rope while the rope works by keeping the barb in place.
This type of twist allows the fence to be stretched, but the main advantages of this product go far beyond. Manufactured with smaller diameter wires than those used in more rudimentary techniques, the alternating twisting technique results in a lighter barbed - and as in the wire artifacts market weight is a major factor in the formation of the product price, these ones represent a lower cost for the final consumer, with the same quality and resistance as the continuous twist wires.
It is not by chance that alternating twisted barbed wires represent 90% of current barbed wire sales in Brazil.
The alternating twist Morlan barbed wires are: Nelore®, Nelore ZN3®, Cercaço® and Cercaço ZN3®.
|Carga Min. Ruptura||Classe 250|
|Diâmetro dos fios||1,60 mm|
|Espaçamento entre Farpas||125 mm|
|Camada de Zinco||Pesada|